(large models, including the D4 for domestic use and the D8 and.

Over time, this seal can deteriorate, fall apart or become compressed, allowing air to escape and causing that irritating whistle.. We stock the correct replacement foam seal, and to make things easier, we have filmed a short video showing exactly where it goes and how to fit it.If you have found your way here after wondering whether you have been sent the wrong part.

(we get many “don’t fit” emails about these – they do)., rest assured, you have not.This guide will clear up the confusion.. Where Does the Seal Go?.

One common mistake is assuming the foam seal replaces the visible rubber O-ring near the hose inlet assembly’s connection to the bag.This foam seal fits deeper inside the housing, in a location that is not immediately obvious..

The number of screws you need to remove will depend on your model:.

On later X4 and X7 models, you will usually need to remove two screws.We don’t cut keys, sell you a tin of paint or a mousetrap.

You’re probably familiar with the phrase,.“Jack of all trades, master of none”.. We’re the place some local repair shops quietly bring people’s Sebos to when they can’t figure out the problem.. Having a Jack of all trades trying to fix your Sebo isn’t ideal – use a specialist Sebo service centre and remove doubt and uncertainty.

Our specialty gives us the edge over small local repair shops.There’s nothing wrong with your Sebo that our chaps haven’t seen before.