Snip away any snags with scissors rather than pulling them out.

The Gtech Multi Mk2’s brush should now be clear of any tangles and ready to use.. Related Article:.Guide to Cleaning the Gtech Multi Mk2’s Filter.

It’s important to regularly remove any hair that’s become tangled around the Gtech Multi Mk2’s brush bar.Tangles can reduce the efficiency of the brush, leading to poor cleaning performance..The good news is that it’s easy to take out the brush and cut away the hair.

Just follow the steps above and your vacuum will be back to full performance before you know it!.Do you have any questions about how to remove hair from the Gtech Multi Mk2’s brush bar?

Please use the comments section below.

You may also want to read our guide to.Step 1: Unplug And Prepare The Vacuum.

It sounds obvious, but the first step to replacing the V6 battery is to make sure the vacuum isn’t plugged into the charger..Performing any maintenance on a vacuum while it’s plugged into the mains power supply could risk electrocution.

It’s also impossible to remove the V6 battery when it’s plugged in.. Once the vacuum has been unplugged, prepare your V6 for a battery change with the following three steps:.Detach the wand to make the vacuum easier to hold..