White vinegar contains acetic acid, which can remove many stains without damaging the carpet..

Remove the filter from the filter housing.. Run the filter under cold water to rinse away dirt and other debris.Keep rinsing until the water runs clear..

Allow at least 24 hours for the filter to fully dry.. Once dry, place the filter back into the housing, then replace inside the dust cup..However, you may want to perform the next step before replacing the filter..The instructions above are for a cordless Dirt Devil.

Many corded upright Dirt Devil vacuums have two filters, so you may need to clean the exhaust filter too (although check the manual to ensure that it’s washable.).Cleaning other Dirt Devil filters is similar, but make sure you read your instruction manual to ensure you’re using the right method.

cleaning washable filters once each month.

You shouldn’t use any sort of soap or detergent when cleaning your Dirt Devil filter.We need to restore the airflow if we want to prevent the thermal cut-out from being activated.. Keep in mind that an overheating vacuum will usually work for a while, before cutting out during use.

If your vacuum cleaner won’t start at all – even if you’ve left it more than 24 hours to cool down – then overheating is probably not the issue.. Why Does a Vax Vacuum Overheat?.There are several reasons why a Vax may overheat.

Here’s an overview of the most common, with tips for solving the issue.. Don’t Ignore the Thermal Cut-Out.Never try to use your Vax vacuum cleaner if it’s overheating.. Switch it off and allow 24 hours for it to cool, while trying to solutions below.