Even if it’s only a packet of bags, it’s better than taking it to the tip.. We also have shop floor demonstrators of most models so you can try them before you buy.

If you have found your way here after wondering whether you have been sent the wrong part.(we get many “don’t fit” emails about these – they do).

, rest assured, you have not.This guide will clear up the confusion.. Where Does the Seal Go?.One common mistake is assuming the foam seal replaces the visible rubber O-ring near the hose inlet assembly’s connection to the bag.

This foam seal fits deeper inside the housing, in a location that is not immediately obvious..The number of screws you need to remove will depend on your model:.

On later X4 and X7 models, you will usually need to remove two screws.

On earlier models like the X1, and early X1.1 and X4, there is typically only one screw at the top.We’d suggest not.

What if your Sebo X4 Excel is in pieces all over the floor and he starts that sharp intake of breath through the teeth thing?That’s usually a harbinger of a very large bill, isn’t it?

And you’re a captive now with your machine in bits and a man on your sofa drinking your tea.. On our advice forums.are several horror stories.